Flanged diecast box for electrical assemblies, relays, etc.
VAT
Ultrasonic reversing sensors built into a EU numberplate shroud with wireless in car dashboard monitor, A cost effective and easy to install auxiliary reversing warning device which can help prevent damage to vehicles, caravans and trailers when reversing.
(If installed externally on a trailer, it is recomended to install control module in a waterproof box)
VAT
12N plated bypass kit with TF2218/7H Smart Bypass and all connectors, cables and fuses for installation
VAT
13 pin unplated socket with TF2218/7H Smart Bypass and TF1170-3 30A combi charging relay, with all connectors, cables and fuses needed for an installation.
VAT
12N unplated bypass kit with TF2218/7H Smart Bypass and all connectors, cables and fuses for installation
VAT
13 pin unplated socket with TF2217JAG Smart Bypass for negatively switched vehicles and TF1170-3 30A combi charging relay, with all connectors, cables and fuses needed for an installation.
VAT
12V 22 amp voltage-sensing relay: switches power to a caravan's battery-charging and fridge circuits when vehicle alternator is charging. Protects the vehicle battery from drain when the engine is off. Voltage-sensitive switching - requires no trigger.
VAT
Trailer 7-pin lighting socket (12N) with rear seal, wired with 2m of 7-core cable, on a mounting plate.
VAT
Un-wired standard plastic 7 pin trailer 12N lighting socket with screw terminals to accept the trailer 7-core cable that comes with a gasket seal, three M5 x 30mm Bots and Nuts and a Single mounting plate TF1410.
VAT
Un-wired standard plastic 7 pin trailer 12S Power socket with screw terminals to accept the trailer 7-core cable.
With a gasket seal, three M5 x 30mm Bots and Nuts and a Single mounting plate TF1410.
VAT
Black steel mounting plate that is secured between the towball and the towbar. Will carry one 12N, 12S or 13-pin socket. Has a slot to allow the wired socket to be put in sideways rather than be threaded through the centre hole.
VAT
Sealed bypass with long input and output leads. For tippers, etc. Puts no load on the vehicle light circuits. Compatible with most vehicles including PWM systems.
Can be used as part of a 24V to 12V signal voltage dropper system.
VAT
Potted and Sealed bypass with hard wired 1m input and 2m output leads. For pickup trucks etc. Puts no load on the vehicle light circuits. Compatible with most vehicles including PWM systems.
Can be used as part of a 24V to 12V signal voltage dropper system.
VAT
TF2323 SmartCAN2 Kit is a vehicle-specific 12N CANbus-controlled trailer interface fitting kit
This kit has everything you need for a 13pin installation to operate the trailer road lights.
For caravan 12S power and split charging please use the TF2324 kit.
When ordering, please specify the car you are fitting
The list of compatible vehicles is below, under More Information.
VAT
This unit is used on vehicles which have a switching pair of rear lights when the rear/boot door is opened, (Eg: Vauxhall Insignea Sports Tourer) and you dont want to fit a second relay.
this unit allows you to take both outputs to one relay by merging the signals without signal contamination.
VAT
Towball boot black, no logo. Covers the towball and bolts.
VAT