TF115FL  Audible Monitor with flying lead    

This is a special version of the TF1152. It is fitted with a 4 metre twin flying lead, connected where the buzzer's positive lead would normally be connected, and supplied with a separate buzzer which can be connected to the flying lead.
In all other respects its function and operation are the same as the TF1152.

It is fitted in vehicles where the buzzer has to be remote from the monitoring circuits. A example would be in a pickup. The monitor would be installed close to the rear lamps of the pickup whilst the buzzer, to be audible to the driver, would be placed in the cab.
A panel lamp or similar device can be connected in place of the buzzer if required.

TF115FL

Instructions: Top
Refer to the General Instructions and Chart A in the section 12N Wiring before following these instructions.
Socket
Pin No.		 7-core cable
colour		  to  Relay wire
colour or
terminal No.		 Relay wire
colour or
terminal No.		  to  Vehicle Circuit
1 Yellow to Yellow Yellow/White to LH Flasher
2 Blue to Direct Direct to Fog Lamp
3 White to Chassis White to Chassis earth
4 Green to Green Green/White to RH Flasher
5 Brown to Direct Direct * to RH tail light
6 Red to Direct Direct * to Brake Lights
7 Black to Direct Direct * to LH tail light
- - - - Twin to Remote Buzzer
* Unless fitting a fog cut-out or bypass relay.
     TF115FL  Audible Monitor

Buzzer does not sound		    
      Check all connections.
  Check trailer (test board) flashers are working.
  Check your test board is drawing enough current (21watts) to make the buzzer work properly. LED testers do not draw significant current.
Buzzer is not loud enough
  Check it has not been trapped or covered.
  Move it to a better place.
  Fix it to a surface that resonates.