TF2560 "Flasher-On" Alarm with Clone Universal Adaptor
Warns driver when flasher has been left on by mistake.
For vehicles with conventional three, four or five pin flasher relays 12 volt, negative earth.
Locate the flasher relay.
Switch off the ignition.
Remove the vehicle flasher relay from its carrier (in fuse box etc.) Insert the tabs on the wires into the clone block so that the protruding blades exactly match the tabs of the vehicle flasher relay. (Be careful not to "mirror-image" them.) Push the insulated terminals of the blue, red and white wires onto the tabs (flat pins) of the flasher relay following the order shown in the chart below. If the flasher relay has more than three tabs use the grey wire(s) to link these tabs to the clone block to reproduce exactly the pin-out pattern of the relay.
Wire colour Function Pin Marking
White Earth on Flasher 31, E, -
Blue Supply 49, B, +, 15
Red Indicator switch 49a, L, C. Com, 54L
Push the completed Clone into the place vacated by the flasher relay, stow the relay in a suitable adjacent space and fix the flasher-on sounder in a suitable place so that it will be audible.
Switch on the ignition and the flashers (left or right). After approximately 30 seconds the flasher-on alarm will begin to sound.